







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Florence-Graham, CA
Asphalt driveways & resurfacing in Florence-Graham usually means one of two jobs: paving a new asphalt drive over a compacted base, or milling off the worn top inch and laying fresh asphalt over sound existing material. New asphalt paving here typically runs $3,500 – $9,000, and most drives are finished in one to three days, with a short curing window before you park on them. For an exact figure on your lot, call (833) 842-7204 and we’ll walk it with you.
How we build or resurface an asphalt drive, start to finish

Asphalt is not a pour-and-go material. The base does most of the work, and the steps below are the ones that decide whether your drive lasts eight years or twenty-five.
Day 1, morning: site walk and layout
We measure the run, check the slope away from the house, and look at what’s under the existing surface – old concrete, gravel, or bare soil. This is where you decide on thickness (2 inches over an existing sound base versus 3 inches on new construction) and where the water will drain. On narrow Florence-Graham lots, drainage direction is often the first decision, not the last.
Day 1, afternoon: demolition and base prep
If we’re replacing, the old surface comes out and gets hauled. For resurfacing, we mill or grind the top layer to give the new asphalt something to bond to. Then we grade the base, compact it in lifts, and check it with a plate compactor. Skipping compaction is the single most common reason a drive cracks within a couple of years.
Day 2: paving
Hot-mix asphalt goes down in one continuous pass where the run allows it, then gets rolled while it’s still workable. Seams matter here – a cold joint that isn’t rolled properly will open up later. You’ll see the grade and thickness settle into place. For a typical residential drive, this is a one-day operation.
Day 2 or 3: edges, transitions, and cleanup
We finish the apron where the drive meets the street, set any edge restraints, and clean up spoils. If your drive ties into a garage slab or a side gate, that transition gets attention – it’s where water pools if it’s off by even a fraction of an inch.
Curing window: 24 to 72 hours
You’ll keep vehicles off the new surface for at least 24 hours, longer in cool weather. This is the one stretch where a homeowner has to plan ahead. We flag it clearly so nobody parks on fresh asphalt and leaves tire depressions.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Asphalt isn’t one product. The choices below are the ones that actually change how your drive looks, holds up, and costs out.
- New full-depth asphalt: the strongest option, best when the base is failing. Costs more because of excavation and hauling, but resets the clock entirely.
- Mill-and-overlay resurfacing: the top inch comes off and fresh asphalt goes on. Cheaper than a full rebuild and right for a drive whose base is still solid but whose surface is raveling or cracked.
- Thickness: 2 inches over a sound base, 3 inches for heavier use or new construction. Trucks and trailers push you toward the thicker spec.
- Aggregate mix: standard mixes are fine for most homes. A coarser mix resists rutting better on a slope; a finer mix looks cleaner on a short, flat run.
- Edge treatment: asphalt edges crumble without restraint. A compacted shoulder or a concrete curb keeps the edge tight for years.
- Seal coat: a protective top layer applied after curing. It slows UV aging and keeps the surface looking fresh, but it’s maintenance, not structure.
What Asphalt Driveways & Resurfacing costs in Florence-Graham, CA

Most asphalt driveway work in Florence-Graham lands between $3,500 and $9,000 for paving, or $5,000 – $14,000 when the job means a full driveway replacement with new base. Here’s what pushes a job toward one end or the other:
| Line item | Typical range |
|---|---|
| Asphalt driveway paving (new or overlay) | $3,500 – $9,000 |
| Full driveway replacement (demo, base, new asphalt) | $5,000 – $14,000 |
| Seal coating after cure | $250 – $700 |
Four variables move that number the most. Square footage is the obvious one. Existing condition matters more – a sound base means overlay pricing, a failed base means excavation. Access is a real cost driver on narrow Florence-Graham lots where equipment has to fit through a tight side yard. Drainage and grading can add scope if water currently runs toward the house or a neighbor’s lot. A written estimate spells out thickness, base prep, hauling, and edge work line by line. What it typically does not include: seal coating (priced separately after cure) and any concrete work at the apron or garage transition, which we’d quote if your property needs it as part of a full Driveway & Pavers in Florence-Graham scope.
See the difference
Before
After
Before
After
Before
AfterWhat Florence-Graham homes specifically do to this job
Florence-Graham is unincorporated LA County, so driveway and site permits route through LA County Public Works rather than the City of LA – a detail that trips up contractors used to city processes and one we plan around from the first call. The housing stock here is mostly 1920s – 1950s single-story stucco bungalows on 5,000 – 6,000 square foot lots, and a lot of these drives were poured or paved decades ago and never rebuilt. We see the same failures across 90001: raveled surfaces from years of summer heat, alligator cracking where the base gave out, and edges that crumbled because nothing restrained them. The warm, dry summers and mild winters are kind to asphalt compared to colder climates, but UV and heat cycling still age the surface, and the expansive clay under parts of the area can shift a base that wasn’t compacted properly. Families here often stay in the home and add on rather than move, so we regularly tie a new drive into a garage conversion or an accessory unit build – homeowners often pair this with ADU Site Prep & Utilities in Florence-Graham when the drive is going to serve a new unit. Our crews work bilingually as a matter of course, and we’re comfortable with cash-pay projects.
Serving Florence-Graham, CA – Our Local Coverage Area
We serve Florence-Graham and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Florence-Graham

Most jobs run one to three days of active work, plus a 24 to 72 hour curing window before you drive on it. A simple overlay is often a single paving day; a full replacement with excavation and base prep spreads across two or three. Call (833) 842-7204 for a schedule that fits your lot.
Many driveway projects in unincorporated Florence-Graham require a permit through LA County Public Works, especially when the apron meets the street or grading changes. We handle the permit pull and inspection coordination as part of the job, so you’re not chasing the county yourself. Call us to confirm what your specific property needs.
Yes, when the base is sound. Mill-and-overlay resurfacing takes off the top layer and lays fresh asphalt over what’s left, which costs meaningfully less than a full replacement. If the base has failed or the cracking runs deep, an overlay will just crack again and we’ll tell you so upfront. Call (833) 842-7204 and we’ll assess it on site.
New paving runs $3,500 – $9,000, and a full replacement with new base runs $5,000 – $14,000. Size, existing condition, access, and drainage scope are what push a job to either end of that range. Call (833) 842-7204 for an exact quote – estimates are free.
No. Our written estimate is what you pay – upfront pricing, no surprises. If we open the base and find something we couldn’t see (buried concrete, a failed utility line), we stop and talk to you before any change, not after. Every project carries our 730-Day Done Right Promise, and calls are answered by a live person around the clock. Call (833) 842-7204 to get your free estimate scheduled.
Get a free estimate on your Florence-Graham asphalt drive
Call (833) 842-7204 to schedule a free on-site estimate for asphalt driveways & resurfacing in Florence-Graham. On the call we’ll ask a few questions about your drive – size, age, and whether it’s cracking or just worn – then set a time to walk the property. You’ll get a written line-item quote, clear on thickness and base prep, with the 730-Day Done Right Promise behind the work. Our Driveway & Pavers service, along with our Florence-Graham coverage and jobs like Chain Link Fence in Florence-Graham, rounds out the exterior work we handle. Live person, 24/7.
Written by the team at Groundwork Construction Co.












