







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Inglewood, CA: What It Takes and What It Costs
Door installation in Inglewood, CA, usually runs $650 – $2,800 for a standard exterior or interior door, and $1,200 – $4,500 when a structural opening, sidelight, or custom build is involved. A typical exterior door replacement is a one-day job; a new opening framed into a wall takes two to three days with inspection. Call (833) 842-7204 and we’ll walk you through the real scope for your door before you spend a dollar.
The reason we lead with cost here is that door installation in Inglewood is rarely a problem with the door. It sits on the wrong side of salt air and moisture that come with this stretch of coast, and the failure shows up on the frame and hardware long before the door itself gives out.
Salt Air Corrosion and Door Installation in Inglewood: What Fails First

The most common failure we see on Inglewood exterior doors isn’t a warped slab – it’s the frame. Marine-layer moisture pushes through exterior seals overnight and dries out by mid-morning for roughly eight months of the year near LAX. That cycle rusts through standard steel hinges, chestnut-browns the latches, and grows white oxide blooms on aluminum thresholds in three to four years. Stainless or zinc-coated hardware and a proper exterior weather seal change that timeline to fifteen years or more.
If you’ve watched a door start to stick in foggy weather and drag by August, that’s an install problem and a material problem together. Our Windows & Doors team uses galvanized or coated fasteners, stainless hinges, and moisture-blocking flashing on every exterior door we set. The door under it may be builder-grade; the hardware and seals holding it are not.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
How Door Installation Works, Step by Step
Every door job we run breaks into five stages. Here’s what each one actually means on an Inglewood house.
Stage 1: Site Visit and Measurements (Day 0, 45 – 60 minutes)
We measure the rough opening, not the door. On 1920s – 1950s Inglewood bungalows the wall thickness and out-of-square frames are the real variables, and getting the rough opening wrong means the door won’t sit flush no matter how good the slab is. At this visit you’ll pick the door type, material, and swing direction, and we’ll write a line-item estimate right there. No surprises later.
Stage 2: Permit and Ordering (Day 1 to Day 5)
Exterior door replacements on single-family homes in Inglewood generally don’t require a building permit, but any structural opening change, new door where none existed, or addition of a sidelight does. We’ll tell you which category your job falls into and pull the permit through the City of Inglewood building department. Interior door swaps don’t need a permit. Lead time on custom or non-standard size doors runs three to six weeks; standard sizes are faster.
Stage 3: Demo and Prep (Day 1 of install, 2 – 4 hours)
Out with the old door, frame, and threshold. On older Inglewood homes we always check for rot behind the trim, because stucco walls hold moisture against the frame. If there’s rot or a compromised rough opening, we show it to you before we proceed. We don’t hide it in a change order.
Stage 4: Setting and Sealing (Day 1, 3 – 5 hours)
New frame, shimmed and level, then the door set, hung, and adjusted for a consistent reveal on every edge. Then flashing, sealant, weatherstripping, and hardware. This is where proper door installation separates a 5-year job from a 20-year job. We check the gap at the strike plate, the lock alignment, and the threshold seal before we call it done.
Stage 5: Final Inspection and Walkthrough (Day 1 or Day 2)
We open and close the door through its full range, confirm it latches cleanly, and check the exterior seal against a garden hose. If a permit was pulled, we schedule the inspection and wait for the City of Inglewood to sign off before you sign off. Every install is covered by our 730-Day Done Right Promise.
The Door Options You’ll Choose Between
Here’s what actually goes into the decision, with the honest trade-offs on each.
- Material – steel, fiberglass, wood, or aluminum: Steel exterior doors start around $500 and are the bread and butter of Inglewood installs. Fiberglass runs $700 – $1,500 and holds paint better in coastal humidity but looks less like real wood over time. Solid wood starts around $1,200 and needs refinishing every few years near the ocean. Aluminum is the right call for garage and utility doors.
- Interior hollow-core vs. solid-core: Hollow-core doors run $200 – $400 installed and suit bedrooms and closets. Solid-core runs $400 – $800 and dampens sound between rooms – worth it for a home office or a room near a busy street.
- Pre-hung vs. slab: Pre-hung doors come with the frame attached and are faster, cheaper, and stronger for exterior use. Slabs keep the existing frame and run $150 – $400 less but only make sense if the existing frame is rot-free and square.
- Hardware and finish: Satin nickel and brushed stainless hold up best in Inglewood’s marine air. Plain carbon steel with a brass finish looks premium but will spot and pit within a few years on an exterior door. We’ll steer you off that choice if the door faces west toward the marina layer.
- Energy performance: On exterior doors, insulated cores, low-E glass, and proper sweeps make a measurable difference in the summer cooling bill. On Inglewood homes built before 1960, adding a well-sealed exterior door alongside new framing often beats an impact window upgrade on bang-for-buck.
See the difference
Before
After
Before
After
Before
AfterWhat Door Installation Costs in Inglewood, CA
Door installation pricing in Inglewood typically breaks down into these ranges:
| Job Type | Typical Cost Range |
|---|---|
| Interior door replacement (hollow-core) | $250 – $500 |
| Interior door replacement (solid-core) | $450 – $900 |
| Standard exterior door replacement | $650 – $1,400 |
| Exterior door with sidelights | $1,400 – $2,800 |
| Sliding patio door replacement | $1,800 – $4,500 |
| New opening cut into existing wall (structural) | $2,000 – $4,500 |
| Storm and screen door install | $350 – $800 |
What pushes a job toward the high end:
Material grade. A $400 hollow-core interior door and a $1,800 solid mahogany exterior door both install in hours. The labor is similar; the materials are not.
Opening condition. If the existing frame is rotten, out-of-square, or was originally set into a rough opening two inches off plumb, we’re doing framing correction before the door goes in. That’s real labor.
Structural work. Any new opening in a load-bearing wall is a different scope. Header fabrication, temporary shoring, and a permit – budget $2,000+ over a straight swap.
Exterior finish work. Stucco patches, threshold transitions, and touchup after a door swap add $100 – $400 depending on how much of the surrounding wall gets disturbed.
Permit and inspection. City of Inglewood permits for structural changes typically run $200 – $450 depending on scope. On straight replacements, no permit, no fee.
Any estimate we hand you is a written line-item quote. The number you see is the number you pay. If we hit something unexpected behind the wall, we show you before we proceed and get your approval in writing.
What Inglewood Homes Specifically Do to This Job

Inglewood is doing two things at once right now, and that shapes door installation here more than in any neighboring city. A pre-1950 bungalow block off Prairie Avenue and a new-construction build-out around SoFi and the Intuit Dome are on the same job board, and the City of Inglewood permit office treats them differently. Legacy homes with unpermitted additions from decades back now get extra scrutiny because of the post-SoFi enforcement climate. If your exterior door install touches a wall that was added without a permit, expect the inspector to flag it.
On the flats west of Prairie, we find original door hardware and framing that has never been touched since the 1940s. The old-growth fir around the rough opening usually looks fine from the outside and is soft underneath. We check it every time. Marine layer moisture cycling through a stucco wall that has no modern weather barrier is what got it there.
Door installation is often part of a wider exterior project on these homes – homeowners frequently pair a front-door replacement with new stucco patching or a window upgrade. If that’s your scope, it’s worth looking at the full Windows & Doors in Inglewood work and deciding whether to bundle. Or, if you’re headed the other direction and converting a detached garage into living space, our Garage Conversion ADU in Inglewood work often adds interior and exterior doors in the same build.
Serving Inglewood, CA – Our Local Coverage Area
We serve Inglewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Door Installation in Inglewood
A standard exterior or interior door replacement takes one day, start to finish, usually three to five hours for the install itself. New structural openings add two to three days for framing, drywall patch, and inspection. Custom door orders add three to six weeks of lead time before the install day even starts.
A like-for-like swap of an existing exterior or interior door in the same opening does not require a permit. New openings, structural changes, and door additions require a City of Inglewood building permit and inspection. We tell you which category your job is in during the estimate, and we pull the permit if it’s needed – you don’t have to chase the building department.
Interior door replacement runs $250 – $900 installed, standard exterior doors run $650 – $1,400, and exterior doors with sidelights or structural openings run $1,400 – $4,500. Call us for an exact quote on your specific door and opening – estimates are free.
No, our written estimate is the price we hold you to, assuming the scope doesn’t change. If we open the wall and find rot or a structural issue we couldn’t see at the estimate, we stop, show you, and get written approval before adding a dollar. The change order is your call, not ours.
Our workmanship is covered by the 730-Day Done Right Promise – if anything we installed isn’t right, we make it right, for two years. The door and hardware carry their own manufacturer warranties on top of that. That’s about as strong as door installation coverage gets in Inglewood.
Get a Free Door Installation Estimate in Inglewood

Call (833) 842-7204 for a free on-site estimate for door installation in Inglewood. We come to your house, measure the actual rough opening, look at what’s behind the trim, and hand you a line-item written quote the same visit. No pressure, no follow-up calls, no surprises. If you’re comparing contractors, call us last – we’re comfortable being measured against anyone.
Written by the team at Groundwork Construction Co. of Inglewood.












