







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Inglewood, CA: What It Costs and How Long It Takes
Asphalt driveways & resurfacing in Inglewood typically run $3,500 – $9,000 for a new asphalt pour and $250 – $700 for a reseal, and a full replacement lands in the $5,000 – $14,000 band when the old base has to come out. A straightforward new asphalt driveway is usually a two-day job: grading and base on day one, hot-mix and compaction on day two, then a cure window before you park on it. Call (833) 842-7204 for a free on-site estimate with a written line-item quote.
How We Build and Resurface an Asphalt Driveway: Stage by Stage

Asphalt isn’t poured like concrete. It’s a layered system, and most of the work happens before a single ton of hot-mix shows up. Here’s the real sequence, with the decisions you’ll be making at each point.
1. Site evaluation and layout (about 1 hour)
We walk the driveway, check the slope away from the house, and look at what’s underneath, which on Inglewood’s older flats often means old concrete, root heave, or a drain that goes nowhere. You decide the apron width, the parking depth, and whether the surface stays straight or gets a curve. We measure for drainage so water runs to the street, not the garage sill.
2. Demolition and removal (half a day to a full day)
If the existing surface is failing, it comes out, and that debris gets hauled the same day. A resurface doesn’t skip this step; we still strip the loose top layer and clean off the old oils and plant matter that would keep the new asphalt from bonding. This is the stage where the price either holds or changes, so we confirm the base condition with you before we dig.
3. Grading and aggregate base (a full day)
We cut and compact a crushed-stone base, usually 4 to 6 inches, and set the fall of the driveway so surface water has somewhere to go. On a lot near the Forum or SoFi where the grade already tilts, we build up low spots and tie the driveway into the existing drainage. A weak base is why so many driveways crack within two years, so we don’t rush this part.
4. Hot-mix asphalt placement (a few hours, weather permitting)
The asphalt arrives at temperature, gets spread with a paver, and is compacted in passes with a roller to the density it needs. For a standard residential driveway we lay 2 inches of compacted asphalt over the base; heavier traffic or a longer pull sometimes calls for a thicker lift. You’ll want to keep cars off it for a few days and keep it dry for the first 24 to 48 hours.
5. Sealing and cure (scheduled a few months out)
New asphalt cures and lightens over the first several months. We recommend the first seal coat after that initial cure, then resealing every two to three years depending on sun and traffic. It’s the cheapest step in the whole job and the one that protects everything under it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Asphalt Options You’ll Choose Between
The material decisions here are narrow, but a few of them change both the price and how the driveway ages.
- Hot-mix vs. resurfacing an existing slab: A full new pour is the durable choice when the base is failing. Resurfacing an overlay works when the base is sound and the old surface is only weathered; it saves money but won’t fix structural cracks.
- Standard asphalt vs. a reinforced lift: For a longer driveway or one that carries a heavy vehicle, a thicker compacted lift rides better and cracks less. It costs more up front and pays off over the years.
- Aggregate base depth: A deeper compacted base holds up on soft or previously disturbed ground. This is the single biggest driver of how long the driveway lasts, and it’s easy to skip when a bid looks cheap.
- Edge restraints: A poured curb or edging keeps the asphalt from spreading at the sides. Worth it on any driveway wider than a single car.
- Drainage tie-in: A channel drain or a graded slope away from the garage. Essential on tight Inglewood lots where the driveway sits between two properties.
- Seal coat schedule: Latex-based sealers that flex with the surface and don’t turn brittle in the sun; a straightforward option that most homeowners here choose.
Where a project grows past the driveway into a larger hardscape plan, it usually belongs in our wider Driveway & Pavers in Inglewood work, and our Driveway & Pavers team handles the mixed-material side of that.
What Asphalt Driveways & Resurfacing Costs in Inglewood, CA

Expect $3,500 – $9,000 for new asphalt paving, $5,000 – $14,000 for a full replacement that includes tear-out and hauling, and $250 – $700 for sealing. Those numbers move with five things.
- Size and slope: A short single-car apron sits near the low end; a long two-car pull with a grade change pushes toward the top.
- Condition of the existing surface: If the old asphalt or concrete comes out easily, the job stays in range. Hidden root heave, buried debris, or a failing base adds time and hauling.
- Base depth and reinforcement: A deeper compacted base and thicker lift cost more and last longer.
- Drainage: A channel drain or regrading to protect the garage adds a line item.
- Permit scope: If the driveway ties into the curb, sidewalk, or a city right-of-way, that changes how the work is inspected and approved.
A written estimate from us lists each of those separately: removal, base, asphalt tonnage, compaction, drainage, and sealing. It doesn’t hide a lump sum, and the number you see is the number you pay. What’s typically not in the base quote is anything discovered mid-job that wasn’t visible at the walk-through; we bring you the change in writing before we do it, not after.
See the difference
Before
After
Before
After
Before
AfterWhat Inglewood Homes Specifically Do to This Job
Inglewood construction is defined by a collision of forces you don’t see in neighboring cities. The transformation around SoFi Stadium, the Intuit Dome, and the Kia Forum has pulled a wave of permitted ADU work and seismic retrofit into the same blocks as a huge stock of pre-1950 bungalows and small stucco duplexes on tight lots. That matters for a driveway because those older houses sit on decades-old surfaces, unpermitted additions, and slab or base conditions nobody recorded. When we tear out an old apron on the flats west of Prairie Avenue, we’re ready for whatever the past owner buried under it. And because Inglewood sits in the coastal-influenced LA basin near LAX, the marine layer and salt-laden onshore air eat exposed surfaces, metal edging, and drainage hardware faster than inland tract homes face. That’s why we specify corrosion-resistant edging and check the drainage tie-in carefully: stucco and pavement here age by moisture cycling, not freeze-thaw, so water management does more for a driveway’s life than any seal coat alone. The City of Inglewood permit office has been under real volume pressure since the stadium build-out, so we plan inspection timing early rather than discovering it mid-job.
Serving Inglewood, CA – Our Local Coverage Area
We serve Inglewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Inglewood

Most asphalt driveways in Inglewood take two working days for grading and paving, then a few days of cure before you park on them. Larger jobs with a lot of tear-out or drainage work can run three to four days. Call (833) 842-7204 for a free estimate and a firm timeline for your driveway.
Often not for a simple like-for-like resurfacing, but any work that touches the curb, sidewalk, or city right-of-way in Inglewood typically requires permits and inspection. Older Inglewood lots with legacy additions or unpermitted work may also trigger extra review, and the City of Inglewood scrutinizes those closely now. We confirm the permit scope before work starts so there are no surprises. Call us to sort out what your driveway needs.
Yes, when the base is sound and the old surface is only weathered. A resurface overlay saves money and time, but it won’t fix structural cracking or a failing base. We inspect the existing driveway and tell you honestly which path is right. Call (833) 842-7204 for that assessment.
A full replacement in Inglewood runs about $5,000 – $14,000 depending on size, base condition, and drainage, while new paving without full tear-out is $3,500 – $9,000. Call (833) 842-7204 for an exact quote, and estimates are free with a written line-item breakdown.
Every driveway we install is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. Our technicians have up to 12 years of experience getting this work to hold up in our coastal moisture and salt air. Call (833) 842-7204 to schedule a free estimate and go over the warranty in person.
Get Your Free Asphalt Driveway Estimate in Inglewood
If you’re planning asphalt driveways & resurfacing in Inglewood, the first step is a free on-site estimate. We’ll walk the driveway with you, measure for drainage, and hand you a written line-item quote with no surprise changes. Our technicians are background-checked and arrive in uniform, and calls are answered by a live person 24/7. And if a bigger project is brewing, our team also handles Chain Link Fence in Inglewood and ADU Site Prep & Utilities in Inglewood, and we cover the whole of Inglewood. Call (833) 842-7204 today to schedule your free estimate.
Written by the team at Groundwork Construction Co.












