







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Compton, CA: What It Costs and How Long It Takes
A chain link fence in Compton, CA typically runs $3,500 – $9,000 for a standard residential lot, installed in two to four days once materials are on site. That covers posts set in concrete, top rail, tension bands, and a walk gate. Most Compton yards land in the $4,000 – $6,500 band. Call (833) 842-7204 for a free on-site estimate that puts a written number on your specific lot, not a ballpark. Spring corrosion here eats gate hardware faster than most homeowners expect, and that shapes what we spec.
How We Build a Chain Link Fence in Compton, Day by Day

Every job runs on the same sequence. Here’s what actually happens, and where your decisions land.
- Day 1 morning – layout and utility locate. We walk the property line with you and mark the corner posts. Before anyone digs, we confirm the 811 locate on gas, water, and Comcast/SoCal Edison runs. On 1940s – 1960s Compton lots with detached garages, the rear line often sits within a foot of old lateral plumbing, so we figure that out first, not after a shovel hits a line.
- Day 1 afternoon – demo and post setting. We pull the old fence, if any, and set line posts in concrete 24 – 30 inches deep depending on soil. This is where we spec galvanized posts and stainless tension bands, not standard zinc, because of the marine air. You decide terminal post placement, gate hinges side, and whether you want a double-drive gate.
- Day 2 – concrete cure and fabric hang. Posts cure overnight, then we stretch fabric with a come-along, set top rail, and install tension bars. Fabric is 11.5-gauge or 9-gauge depending on what you chose. Gate frames get welded or clamped corners, and we hang gates with nylon rollers and stainless hinge bolts, which is the one thing that separates a gate that lasts here from one that seizes in two summers.
- Day 3 – gate alignment, stretch, and finish. We level gates, adjust tension, and confirm the fabric runs true to the line. You walk the fence with us before we leave.
- Day 4 – final walk and cleanup. We haul off old material, sweep up concrete dust, and hand you the workmanship paperwork. If your fence needs a permit or is part of a larger lot change, we handle that.
Our technicians have up to 12 years of experience on fence and gate work. Every job is covered by the 730-Day Done Right Promise, so if a gate sags or a tension band fails, we come back and fix it, not argue about it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Chain Link Fence
Chain link isn’t one product. Here’s what actually changes the price and how long it lasts in Compton.
- Fabric gauge: 11.5 vs 9 gauge. 11.5-gauge is the light residential standard and the cheaper choice, fine for a backyard divider. 9-gauge is heavier and resists dog damage and prying. Most Compton rear-yard fences are 9-gauge for that reason.
- Post and rail finish: galvanized vs coated. Hot-dipped galvanized is the baseline. Powder-coated or vinyl-clad (black or green) adds $400 – $900 on a typical lot and looks far better from the street. Coated costs more but the coating is the corrosion barrier, which matters here.
- Hardware grade. We use stainless steel tension bands, stainless hinge bolts, and nylon gate rollers by default. Standard zinc hardware is where gates fail first in Compton’s salt air. You can downgrade, but we’ll tell you what it costs you in five years.
- Height and gate type. Four-foot is the residential default. Five- and six-foot add cost and, in some cases, a permit. Walk gate, single drive gate, or double drive gate all change the terminal post count and the price.
- Brands that matter. For the occasional aluminum top rail or gate option, we work with Tamko and Atlas on coated components. Our fence installation service pulls from a curated partner list, not whatever the supply house has in stock. That’s part of Fence Installation here, and chain link is the workhorse of that lineup.
What a Chain Link Fence Costs in Compton, CA

Plan on $3,500 – $9,000 for a full residential chain link fence, installed. A simple rear-yard divider on a standard 6,000-square-foot lot lands near the low end. A full perimeter with a double drive gate, 6-foot height, and coated finish pushes toward the top.
| Line item | Typical range |
|---|---|
| Chain link fence, full residential lot | $3,500 – $9,000 |
| Coated or black vinyl-clad upgrade | add $400 – $900 |
| 9-gauge fabric upgrade | add $300 – $700 |
| Walk gate | $250 – $500 |
| Double drive gate | $600 – $1,400 |
What moves the number: linear footage and lot shape, existing fence demo, gate count, fabric gauge, and finish. A line that runs tight against a detached garage or over a buried slab costs more to set than a clean run across open dirt.
Every estimate is itemized. What’s included: posts, concrete, fabric, rail, hardware, gates, and cleanup. What isn’t always included: permit fees (if required), haul-off of large old-fence volumes, and any utility locate delays. We flag those up front so the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Compton Homes Specifically Do to This Fence Job
Compton is a built-out, working-class suburb where the fence trade is dominated by tear-out-and-replace on 1940s – 1960s stucco tract houses with detached garages. The rear property line often sits within inches of a converted-garage slab or an old lateral line, and informal additions over the decades mean we routinely find fence posts set inside unpermitted footings. We work with that reality: we survey the line, locate utilities, and plan post placement around what’s actually in the ground.
Salt air and the marine layer off the South Bay corrode gate hinges and tension bands years before inland fences fail. We spec stainless hardware and nylon rollers as standard for that reason. The Santa Ana wind season also stresses gates and top rail on exposed lots, so we over-build terminal posts on the windward side. Most of our Compton work comes from neighbors referring neighbors on owner-occupied homes, so the fence has to hold up and look right from the street. We cover Compton and the ZIPs 90220, 90221, 90223, and 90224, plus bordering areas toward Willowbrook and Gardena. If the fence is part of a bigger lot change, homeowners often pair it with ADU Site Prep & Utilities in Compton or a new front entry through Door Installation in Compton, and both slot into the same schedule.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Compton

Two to four days for most residential lots, once the utility locate clears and materials are on site. Small rear-yard runs can wrap in a day and a half; full perimeters with multiple gates take closer to four. Call (833) 842-7204 for a timeline on your lot.
Residential fences up to the standard height generally don’t need a permit, but height limits and setbacks vary, and anything over the residential limit or on a corner lot may trigger one. We check the current city requirement and pull the permit if it applies. Call us and we’ll tell you before you commit.
Yes in most cases. We locate utilities first and set posts around existing plumbing, garage slabs, and footings. If a post lands directly on a line, we shift it or set it shallower with additional bracing rather than dig into the line. That’s a conversation we have on site, not after the damage is done.
$3,500 – $9,000 for a full residential lot, with coated finishes, heavy gauge fabric, and extra gates pushing toward the higher end. Call (833) 842-7204 for a written line-item quote, and estimates are free.
Every chain link fence we install is covered by the 730-Day Done Right Promise. If a gate sags, a tension band fails, or a post settles, we make it right. The fence installer we connect you with is licensed and insured as the state requires. Call (833) 842-7204 with questions.
Get a Free Chain Link Fence Estimate in Compton
Call (833) 842-7204 and a live person picks up, any hour. We’ll set a free on-site estimate, walk your property line, and hand you a written number with no change orders and no surprises. If your fence is part of a wider project, our Fence Installation in Compton page covers the full scope. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co..












