







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Alondra Park, CA: What It Costs and How Long It Takes
A chain link fence in Alondra Park, CA typically runs $3,500 to $9,000 for a standard residential lot, and most jobs wrap in two to three working days once the permit clears. That range covers galvanized or vinyl-coated chain link, posts, top rail, tension bands, and a set of gates. If your property line sits on Redondo Beach Blvd or along the Artesia Blvd corridor, expect a faster LA County plan check and a shorter install window than a corner lot with three separate gate configurations. Call (833) 842-7204 and we’ll put an exact, itemized number in writing before anyone digs.
How We Build a Chain Link Fence, Start to Finish

Chain link looks simple until the ground tells you otherwise. Here’s the sequence we run on every Alondra Park job, and where you as the homeowner actually weigh in.
Stage 1: Site walk and boundary confirmation (day 1, about an hour)
We walk the line with you, confirm corners against your property survey or plat map, and mark where posts will land. This is where you decide height (4, 5, or 6 feet), gate count, and whether the fence follows the lot edge or steps down a slope. On the compact post-war lots here, boundaries rarely line up cleanly with what a neighbor assumes, so we settle it before we buy material, not after.
Stage 2: Permit and utility locate (days 1 through 5, mostly waiting)
Because 90260 is unincorporated, the permit goes through LA County Building & Safety, not a city hall. We pull it, and we call for utility marking before we touch a shovel. That marking call is often the longest single delay on the whole job. You’ll get the plan check status from us; you don’t chase anyone.
Stage 3: Demo and removal (day 1 of install, 3 to 6 hours)
Old fence comes down, posts get pulled or cut flush, and we haul it off. If there’s concrete footing around the old posts, we break it out and dispose of it, which adds time on jobs where the previous fence was set deep.
Stage 4: Post setting and curing (day 1 into day 2)
Posts go in concrete footings set below grade, and they need to cure before we hang any fabric. This is the one part of the build that can’t be rushed. On coastal-side lots where soil stays damp, we give the footings the full cure window so a leaning post doesn’t show up two seasons later.
Stage 5: Fabric, rail, tension, and gates (day 2 into day 3)
Top rail, tension bands, and chain link fabric go up, then gates are hung, squared, and adjusted for swing. We walk the finished line with you and hand over the signed-off permit. Trim the first few weeks of growth back from the fence, and it’ll stay square.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Chain Link Fence
Chain link is one product family with real decision points inside it. Here’s what actually changes the outcome.
- Galvanized vs. vinyl-coated: Bare galvanized steel is the durable, lower-cost choice and handles sun well. Vinyl-coated chain link costs more up front but holds color and shrugs off the salt-laden air that’s a constant companion here. On the near-coastal side of Alondra Park, the coating pays for itself in appearance over a decade.
- Gauge and mesh size: Standard residential is 11.5 gauge; 9 gauge feels and lasts notably heavier. You’re buying tension and resistance to sag. For anyone who’s had a loose, saggy fence, 9 gauge is the fix.
- Fence height: 4, 5, or 6 feet. Height is often a code question as much as a preference, and it’s one of the first things the County plan check will flag if you go tall on a corner sightline.
- Gate hardware: Standard swing latches, self-closing hinges, and keyed locks. Cheap hinges are the first thing to sag on a coastal fence, so we spec heavier hinges and stainless fasteners on the parts that move.
- Top rail vs. top tension wire: Top rail stiffens the whole run and looks cleaner; tension wire is the budget option and lets the fence flex more. For rental-grade fencing, tension wire is a fine call.
- Color: Coated chain link comes in the usual greens and blacks, which read softer in a yard than bare silver. The finish is a real aesthetic decision, not an afterthought.
What Chain Link Fence Costs in Alondra Park, CA

Plan on $3,500 to $9,000 for a residential chain link fence in Alondra Park, CA. Five things push a job from the bottom of that range to the top.
- Linear footage and lot shape: A tight rectangular lot is cheap per foot. An L-shaped or corner lot with multiple runs and gates costs more, since each corner and gate adds hardware and labor.
- Existing fence and footing condition: Old concrete footings, roots, or a fence set in rocky ground add demo and removal time.
- Material grade: 9 gauge vinyl-coated chain link with heavy gate hardware sits well above basic galvanized.
- Gate count and type: Every additional gate is a hardware set, a swing adjustment, and often a wider post footing.
- Permit scope and boundary issues: If the property line has to be re-established or the job crosses a County sightline rule, plan check takes longer and the scope grows.
A written estimate from us lists footage, gauge, finish, gate hardware, footing depth, demo and haul-off, and the permit line as separate items. What’s typically not included: redoing old concrete footings beyond normal removal, addressing encroaching roots, or restaking a disputed boundary.
See the difference
Before
After
Before
After
Before
AfterWhat Alondra Park Homes Specifically Do to This Job
Alondra Park is one of the few unincorporated islands in the South Bay, so almost all construction here runs through LA County Building & Safety rather than a city hall. That matters on this specific job: your fence permit and inspection are County, even though your next-door neighbor’s block might be City of Torrance or Gardena. That boundary quirk trips up out-of-area crews working the same street, and it’s exactly why we confirm the permitting authority first. The housing stock here is a tight mix of small 1940s and 1950s stucco tract houses and low-slung 1960s garden apartments, most on compact lots around Alondra Park and along Redondo Beach Blvd and Artesia Blvd. In that housing, the fence failure we see most is post corrosion and footing decay, not fabric wear: persistent morning damp and salt-laden marine air eat at fasteners and footing concrete while the mesh still looks fine. It’s part of the reason most of our Alondra Park jobs pair the fence with other exterior work, and why homeowners often pair this with Door Installation in Alondra Park or ADU Site Prep & Utilities in Alondra Park once they’re already opening up a property line. For the wider scope, see our Fence Installation in Alondra Park page, or the Fence Installation service overview. We cover the whole of Alondra Park, 90260 included.
Serving Alondra Park, CA – Our Local Coverage Area
We serve Alondra Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Alondra Park

Most residential chain link fences here are installed in two to three working days, with plan check adding roughly a week to ten days before install starts. The build itself breaks down as a day for demo and post setting, a cure window, then a day for fabric, rail, and gates. Call (833) 842-7204 for a timeline tied to your lot.
Yes, in most cases a fence permit is required, and because 90260 is unincorporated, it runs through LA County Building & Safety rather than a city. We confirm the correct authority before pulling, since neighboring blocks fall under Torrance or Gardena. Call (833) 842-7204 and we’ll sort out the jurisdiction question on your property.
Rarely. Post footings are narrow and set along the property line, so they typically clear plumbing and irrigation runs, but we call for utility marking before digging so we know exactly what’s underground. Larger landscape plants along the line may need relocating. Call (833) 842-7204 to walk the line with us.
Plan on $3,500 to $9,000 for a standard residential chain link fence, with footage, gauge, finish, and gate count driving where you land. A written estimate breaks each item out so the number doesn’t move once work starts. Call (833) 842-7204 for an exact quote, free.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. Post setting, gate swing, and tension are all part of what that covers. Call (833) 842-7204 to schedule your free estimate.
Get a Free Chain Link Fence Estimate in Alondra Park
Call (833) 842-7204 for a free on-site estimate on your chain link fence in Alondra Park. We’ll walk the property line, confirm whether your address falls under County or city jurisdiction, measure the run, and hand you an itemized written number, not a ballpark. A live person answers around the clock. Financing at 0% for 18 months is available, and projects over $10,000 take $1,000 off.
Written by the team at Groundwork Construction Co.












