







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWhat Shower Replacement Costs in Inglewood, CA: Real Numbers Before the Tile Comes Down
Shower replacement in Inglewood runs from about $3,000 for a straight prefab swap up to $16,000 for a full gut with subfloor repair and custom tile, with most permitted jobs landing in our lead bathroom range of $9,000-$28,000 once the walls are open. The honest number depends on what’s behind the tile: Inglewood’s pre-1965 bungalows often have tile set directly on wood sheathing with no waterproofing, so a “$4,000” quote can climb fast on demo day. Call (833) 842-7204 for a free estimate with upfront pricing, and know the number before we start.
Here’s the problem no online calculator will tell you about. A lot of the housing stock in Inglewood went up between the 1920s and 1950s, and the bathrooms in those homes were tiled straight onto the original wood subfloor. No cement board. No isolation membrane. That was how it was done. The result is decades of moisture wicking into framing that nobody can see until the old surround comes off the wall. Any shower replacement that doesn’t account for that is building a new shower on a rotting foundation, and it’ll fail again inside a few years.

Why the Quote You Got Online Never Matches Demo Day in Inglewood
Prefab-condition estimates assume clean, modern framing and a watertight substrate. Replacing a shower in an untouched bungalow off the flats west of Prairie Avenue is a different job. When we open a wall and find tar paper, wire lath, or tile glued to bare wood, the scope changes, and pretending otherwise is how homeowners get a change-order surprise halfway through.
That mismatch is the whole reason shower replacement cost is so hard to pin down. The tile and the pan are the visible part. The waterproofing and the subfloor underneath are where the real money sits. A contractor who gives you a firm number without opening anything is guessing, and the guess is almost always low.
Since 2014, Groundwork Construction Co. of Inglewood has replaced showers in this exact housing stock, and our technicians have up to 12 years of experience reading what’s behind a wall before committing to a price. We’d rather tell you the honest range up front than sell you a low bid and surprise you later.
Shower Replacement Cost Ranges by Scenario in Inglewood
These three scenarios cover most of what we see in Inglewood, and each one reflects a different level of what’s behind the tile. Your actual number depends on the condition we find, which is why the free estimate matters.
| Scenario | What It Covers | Typical Cost |
|---|---|---|
| Like-for-like prefab replacement | Swap an existing prefab unit, reuse the pan and drain, tile-ready substrate already in place | $3,000-$5,500 |
| New cement board + waterproofing membrane | Demo the old surround, install backer board and a waterproofing membrane, new tile or pan | $5,500-$9,000 |
| Full gut with subfloor repair + custom tile | Strip to framing, replace compromised subfloor and framing, full waterproofing, custom tile, new valve | $9,000-$16,000 |
| Walk-in shower (wider scope) | Barrier-free pan, curbless or low-curb, glass panel, full waterproofing | $4,500-$12,000 |
| Tub-to-shower conversion | Remove tub, convert drain, new pan, surround and waterproofing | $3,500-$10,000 |
Put a different way, most shower-only work falls into our Bathroom Remodeling range of $9,000-$28,000 when the repair scope widens. That upper range isn’t padding. It’s the difference between setting new tile over sound framing and rebuilding a wall that’s been quietly absorbing water since the 1950s.

What “Like-for-Like Replacement” Actually Includes in a Permitted Job
When we quote a like-for-like shower replacement, the price covers a real, permitted scope, not just a new surround hung on the old wall. Here’s what you should be able to see itemized on any bid:
- Demo and disposal of the old shower and surround
- Valve replacement, so you’re not reusing a 20-year-old mixing valve behind new tile
- Backer board installed over the framing
- A waterproofing membrane on the pan and walls before any tile goes up
- New tile or prefab pan, depending on the finish you choose
- Glass, a framed door, or a curtain rod
- A final inspection through the City of Inglewood permit process
Proper waterproofing is the step that separates a shower that lasts from one that leaks into the ceiling below. We build it into every job because skipping it is the single most expensive corner to cut. Once you’re considering more than just the shower, you may want to look at the fuller scope on our Bathroom Remodeling in Inglewood page.
Our upfront pricing means the number on the estimate is the number you pay. If we open a wall and find something genuinely different, we stop, show you, and quote the change in writing before anyone keeps working. That’s how a big improvement stays accessible without hidden surprises. And the work is backed by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction.
The Salt-Air Factor: Why Inglewood Fixtures Age Faster
Inglewood sits close to LAX in the coastal-influenced basin, and the marine layer and salt-laden onshore air do a number on exposed metal. Standard chrome and brass shower fixtures oxidize faster here than the manufacturer’s warranty assumes. Specifying brushed nickel or PVD-coated finishes isn’t a luxury upsell in this climate. It’s practical. It adds a modest amount to the fixture line and buys you years before pitting and flaking show up. If a bid steers you toward plain chrome to save a little, ask why.
Common Local Scenarios We Run Into
Every shower is a little different, but the Inglewood jobs tend to repeat. A few we see often:
- A 1940s bungalow where the original tile is bedded on wire lath over wood, and pulling the surround reveals soft framing around the valve wall. The fix is a partial reframe and new substrate, which moves the job from the $5,500-$9,000 band toward the gut range.
- A small stucco duplex near the stadium district where the shower pan was patched years ago and the drain is undersized. Converting to a walk-in pan means resetting the drain and waterproofing the whole base.
- A home with an unpermitted earlier addition where the shower stall sits slightly off the main footprint. City inspectors now scrutinize legacy work hard, so we pull the correct permits and document everything before the final walkthrough.
- A straightforward prefab swap in a mid-century house that was already updated. Clean scope, done in a day, well within the $3,000-$5,500 band.
The tension between old Inglewood and event-district Inglewood shows up in the bathrooms too. Blocks from the Kia Forum, longtime homes are getting real investment for the first time in decades, and the shower is usually the first thing to go.
Why the Waterproofing Membrane Is the Whole Game
The most common shower failure point is the waterproofing layer behind the tile, not the tile itself. When that layer is skipped or installed wrong, water gets into the wall cavity and the real damage stays invisible until it’s structural. The 730-Day Done Right Promise covers the entire installation, including the membrane, in writing. If something isn’t done right, we come back and make it right. A two-year guarantee on the part of the job most likely to fail gives you real recourse, not a handshake and a promise to check in.
We also answer the phone. Calls are picked up by a live person 24/7, so you’re not leaving a voicemail and waiting until Monday when a shower starts leaking through the ceiling. Our technicians are background-checked and arrive in uniform on every visit. To see how a shower fits into a larger project, start from our home page.
Frequently Asked Questions
Shower replacement in Inglewood typically costs $3,000-$8,500, with most permitted jobs running higher once subfloor and waterproofing repair are included. The wide swing comes down to what’s behind the old tile. Call (833) 842-7204 for an exact quote, and estimates are free.
Repair is cheaper when the leak is isolated, like a failed caulk line or a worn valve, and it usually runs a fraction of a full replacement. Replacement wins once water has reached the substrate, because patching a surround over a wet subfloor only delays the bigger bill. Call (833) 842-7204 and we’ll tell you which side of that line your shower is on, with a free estimate.
A straightforward prefab or like-for-like replacement can often be done in a single visit, while a full gut with subfloor repair takes several days to allow for waterproofing and cure time. We’ll tell you the realistic timeline before we start. Call (833) 842-7204 to get yours scheduled.
Yes, most shower replacements involving a valve change, drain work, or new waterproofing require a permit through the City of Inglewood, and the office scrutinizes legacy work closely. We handle the permitting and the final inspection as part of the job. Call (833) 842-7204 with questions about your project.
Get a Real Number on Your Inglewood Shower
Don’t plan a shower replacement around a quote that assumes a perfect wall. Call Groundwork Construction Co. of Inglewood at (833) 842-7204 for a free estimate and design consult, and we’ll give you upfront pricing before the tile comes down.
What Our Customers Say
"The schedule he gave me at the start was accurate to within four days on a three month job. Anyone who has done a renovation knows how unusual that is."
- Laura Bennett"We lived in the house through the whole thing. He kept the dust wall up, cleaned every Friday, and made sure we always had a working bathroom."
- Craig Whitaker"Change orders were written down and priced before the work happened, every single time. No surprise at the end."
- Keisha Robinson












