







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Compton, CA
Concrete Driveways & Concrete Work in Compton usually means one of two projects: pouring a new driveway slab or replacing a cracked, heaved one. A standard two-car driveway pour runs $4,500 – $12,000 depending on square footage, thickness, and whether the old slab needs a full tear-out. Most single-driveway pours take 2 – 4 days from demo to cure, and a full replacement typically lands between $5,000 and $14,000. Call (833) 842-7204 for a free on-site estimate.
How we run a concrete job, start to finish

Every pour follows the same five-stage sequence. The variables are the condition of what’s underneath and how much has to come out before anything new goes in.
1. Site walk and utility locate (day 1)
We mark the pour limits, check slope and drainage away from the foundation, and call in the utility locate before any cutting starts. On Compton lots, this is also where we check whether an old walkway, planter footing, or informal addition is sitting in the pour zone. You decide the finish and the layout at this stage, because once the forms go down, changes cost money.
2. Demolition and haul-off (day 1 – 2)
Existing concrete gets broken out with a jackhammer or saw-cut at clean joints, then hauled off. A 400-square-foot driveway tear-out usually takes a full day with a two-person crew. If the old slab is sound and only the surface is spalling, we may recommend an overlay instead. That decision gets made here, not later.
3. Subgrade prep and base (day 2)
This is the stage that determines whether the slab lasts. We excavate to depth, compact the subgrade, and lay 4 – 6 inches of compacted Class II base. Compton’s older lots often have shallow or poorly compacted fill from informal additions, so we probe for soft spots before forming. You approve the base thickness and any drainage correction before we move on.
4. Forming, rebar, and pour (day 3)
Forms get set to the final grade with a positive slope away from the house, then #3 or #4 rebar goes in on a grid, typically 12 – 18 inches on center. The pour itself is one day. For a standard driveway, that’s 4 – 6 inches of concrete at 3,500 – 4,000 psi, air-entrained. You confirm the finish before the crew floats it: broom, light salt, or exposed aggregate.
5. Cure, cut, and seal (day 4 onward)
Control joints are cut within 6 – 12 hours of the pour to direct cracking. The slab cures for 7 days before you drive on it and 28 days before it reaches full design strength. Sealing happens after the cure, usually at the 28-day mark or whenever you schedule it. That’s the whole job: five stages, one clear decision point at each.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll pick between
Concrete is not one product. What you choose at the estimate changes what the driveway looks like in year ten.
- Standard broom finish: The default. Rough texture, good traction, hides minor surface wear. Cheapest option and the right call for most Compton driveways. Doesn’t show tire marks the way smooth finishes do.
- Exposed aggregate: The top layer is washed away to reveal stone. More visual interest, better grip when wet. Adds roughly 10 – 20% to the pour cost and takes more skill to place evenly.
- Color hardener and integral color: Pigment mixed into the concrete or broadcast on top. Holds up better than a surface stain. Lighter tones stay cooler under summer sun, which matters during Compton’s late-summer heat events.
- Fiber mesh vs. rebar: Fiber mesh adds tensile strength at lower cost and works fine on lighter-duty slabs. Rebar is the better choice for driveways that see heavier vehicles or have soft subgrade. We’ll tell you which one your site actually needs.
- Thickness: 4 inches is the minimum for a passenger car. 5 – 6 inches handles trucks, RVs, or anything with a heavy load. Going thicker is cheaper than re-pouring a cracked slab later.
We use Quikrete and Sakrete products where the mix specification calls for them, matched to the pour and the climate.
What Concrete Driveways & Concrete Work costs in Compton, CA

Concrete driveway installation in Compton runs $4,500 – $12,000. Replacement runs $5,000 – $14,000. Concrete driveway installation is the range; replacement is the higher end because the tear-out and haul-off are added to the pour. Those numbers hold for standard residential driveways. Here’s what moves a job from the low end to the high end:
- Square footage: A single-wide driveway of 200 – 300 square feet sits at the low end. A wide two-car or RV pad of 500+ square feet pushes toward the top.
- Existing slab condition: Intact slab, small overlay: low end. Full tear-out, broken edges, root intrusion: adds $1,500 – $3,000 over the base pour.
- Base and grading: Flat, compacted site costs less. Soft subgrade, a slope correction, or drainage work adds to the prep line.
- Finish and color: Broom is baseline. Exposed aggregate or integral color adds to the pour cost. A stamped or decorative finish is handled on our separate driveway & pavers scope, not on a standard concrete pour.
- Access and haul distance: Tight side yards, fences in the way, or a long haul to the dump add labor hours.
A written estimate from us breaks out demolition, base, rebar, concrete yardage, finish, and haul-off as separate line items. What typically isn’t included: permit fees if the city requires one for your scope, and any unexpected utility relocation discovered after the locate.
See the difference
Before
After
Before
After
Before
AfterWhat Compton homes specifically do to this job
Compton is a built-out, mid-century suburb. Most lots are full, so nearly every concrete job here is a tear-off or replacement, not a new-build pour. That changes the math. We’re almost always breaking out something that’s been there for decades. On the 1940s-1960s stucco-on-wood-frame tract houses across ZIP codes 90220, 90222, 90223, and 90224, we regularly find driveway slabs poured thin, with little or no base, sometimes over old walkway concrete that was never removed. That’s why so many Compton driveways are cracked and heaved rather than just worn.
The dry South Bay climate helps in one way: very little rain means less freeze-thaw damage than you’d see inland. But the intense late-summer heat and Santa Ana wind season put slabs through constant thermal cycling. Cracks that start hairline widen fast through a hot fall. Many homes here were also expanded informally over the years, so we routinely run into unpermitted additions, converted garages, and non-code electrical that sit in or near the pour zone. When that affects the driveway footprint, we flag it before demo, not after.
Most of our concrete work in Compton is repeat and neighbor-referred, which is why we walk every site before quoting. If your driveway project is part of a full Driveway & Pavers in Compton scope that includes walkways or a patio edge, we quote it as one job. Homeowners converting a detached garage often pair this with ADU Site Prep & Utilities in Compton, since the garage apron and approach get rebuilt at the same time. And when a driveway replacement comes with a new garage or entry door, we handle Door Installation in Compton on the same visit.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Concrete Driveways & Concrete Work in Compton

A standard driveway pour takes 2 – 4 days from demo to finish, with a 7-day wait before you drive on it and full cure at 28 days. Larger replacements with significant base work can run 5 – 6 days. Call (833) 842-7204 for a schedule based on your site.
Most residential driveway replacements don’t require a permit on their own, but a new driveway that changes drainage, grading, or the approach to a public street may trigger one. We check the requirement for your specific scope before work starts and tell you in the estimate. Call (833) 842-7204 to confirm what your project needs.
Sometimes. If the existing slab is structurally sound and only the surface is spalling, an overlay can work. If it’s cracked, heaved, or sitting on bad base, an overlay will fail within a few years. We probe the slab and tell you honestly which one you’re looking at. Call (833) 842-7204 for an on-site assessment.
Concrete driveway installation runs $4,500 – $12,000, and replacement runs $5,000 – $14,000. The range depends on square footage, slab condition, base prep, and finish. Call (833) 842-7204 for a written estimate with line items.
Every project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. The written estimate spells out exactly what’s covered. Call (833) 842-7204 with any questions about the guarantee.
Get a free estimate for Concrete Driveways & Concrete Work in Compton
Call (833) 842-7204 to schedule a free on-site estimate for Concrete Driveways & Concrete Work in Compton. We’ll walk the site, check the base and drainage, and hand you a written line-item quote with the finish options spelled out. No change orders, no surprises. A live person answers the phone any time, day or night. Quotes are free and there’s no pressure to book on the call.
Written by the team at Groundwork Construction Co.












