







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Walnut Park: What It Costs and How Long It Takes
A chain link fence in Walnut Park typically runs $3,500 – $9,000 for a standard residential run, and most jobs are finished in one to three days once materials are on site. You’re usually fencing a tight side yard, a rear alley line, or a shared property boundary on a small infill lot, not a wide suburban back yard. Call (833) 842-7204 and we’ll set up a free on-site estimate with a written, line-item quote so you can see exactly where the number comes from.
How a Chain Link Fence Project Moves From First Call to Last Post

We run this job in five stages. Here’s what actually happens, and where you have decisions to make.
Stage 1: On-site measure and setback check (about 45 minutes)
We walk the line with you and measure every run, corner, and gate opening. On Walnut Park’s narrow parcels this is where we find the real constraints: a rear garage built flush to the property line, a shared fence that isn’t quite where the plat says, or an alley easement that limits where posts can go. You decide the fence height and whether the gate swings in or out at this stage.
Stage 2: Utility locate and layout (1 – 3 business days before digging)
Before anyone puts a shovel in the ground we call for a utility locate. Tight lots mean water, gas, and sewer laterals often run close to the property line, and the last thing you want is a post hole through a sprinkler main or a gas stub. While we wait on the locate, we set string lines and mark post spacing, usually 6 to 10 feet depending on height and wind exposure.
Stage 3: Removal of the old fence and site prep (half a day)
If there’s an old chain link or a rotted wood line in the way, we pull it, haul it off, and clear the footing zone. This is also when you confirm the material grade and finish you want – more on those options below. If the old posts are set in concrete, they get cut at grade and the concrete gets broken out, not left as a trip hazard.
Stage 4: Post setting and concrete cure (day 1 into day 2)
Terminal posts and gate posts get set first, in concrete mixed to a stiff, workable slump. We use Quikrete fastener-set or Sakrete high-strength mix depending on what the soil and post load call for. Concrete needs to set before you load the line, so posts go in on day one and the frame goes up the following morning. On a typical Walnut Park side-yard run that’s a full day of digging and setting.
Stage 5: Frame, mesh, gate, and walkthrough (day 2 into day 3)
Top rail, tension bands, and mesh get pulled and tensioned on day two, and the gate gets hung and adjusted. We walk the whole line with you, check gate swing and latch, and confirm nothing sits proud of grade where a mower will catch it. You sign off, and the workmanship is covered under our 730-Day Done Right Promise – if it’s not right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
Chain link isn’t one product. The choices below are the ones that move both the look and the price.
- Gauge of mesh: 11.5-gauge is the standard residential weight and the better value; 9-gauge is heavier and resists bending and cutting far better. On alley-facing runs where durability matters, 9-gauge earns its keep.
- Coating: Galvanized steel is the cheapest and holds up fine in dry inland air; vinyl-coated (usually green or black) costs more but looks better against stucco and hides rust bloom longer. For a fence that faces a street or neighbor, black vinyl-coated is the usual pick.
- Height: 4-foot is common for a boundary line; 5- and 6-foot runs are typical where you want more privacy or containment. Taller fences need deeper post footings and more bracing, so cost climbs with height.
- Posts and framework: Line posts, terminal posts, and top rail diameter all scale with height and wind load. Heavier pipe and proper diagonal bracing on corners is what keeps a fence straight for years.
- Gates and hardware: Walk gates, double drive gates, and self-closing hinges are all choices here. Alley-loaded lots often need a wider gate for vehicle access, which changes the post and footing spec.
We also set fence lines as part of a wider Fence Installation in Walnut Park project when a homeowner is fencing the full perimeter, and you can see the full scope of what we handle through our Fence Installation service.
What a Chain Link Fence Costs in Walnut Park, CA

Most residential chain link in Walnut Park lands between $3,500 and $9,000. That range covers material, footings, and labor for a typical side-and-rear run. Here’s what pushes a job toward the low or high end:
| Factor | Low end | High end |
|---|---|---|
| Linear footage | Short runs, 60 – 100 ft | Full perimeter, 200+ ft |
| Old fence removal | None, or light | Concrete-set posts to break out |
| Mesh grade | 11.5-gauge galvanized | 9-gauge vinyl-coated |
| Gates | Single walk gate | Wide double drive gate |
| Site access | Open lot, easy staging | Alley-only access, tight setbacks |
| Utility conflicts | Clear locate | Reroute around laterals |
A written estimate from us lists footage, gauge, coating, post and footing spec, gate count, and removal – the number you see is the number you pay, with no change-order surprises. What it doesn’t include unless we spell it out: landscape restoration beyond the fence line, grading, and any permit fees. Call (833) 842-7204 for an exact quote – estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Walnut Park Homes Specifically Do to This Job
Walnut Park is an unincorporated pocket of southeast LA County, wedged between Huntington Park and South Gate in ZIP 90255, and that status changes the paperwork. Because it’s unincorporated, fence permitting and inspection flow through County Public Works and County building codes rather than a city building department – a different workflow than a neighboring city with its own counter. We handle that for you and tell you upfront whether your run needs a permit at all.
The lots themselves shape the work. Most Walnut Park construction is infill on small, tightly packed parcels, and rear detached garages are often built flush to the property line with alley access. That means fence lines run right up against zero-lot-line setbacks, and staging happens in the alley, not the front yard. On the pre-war and post-war stucco bungalows common here, we routinely find rotted posts and termite-damaged footings at the shared property line, so we plan for footing replacement rather than assume the old holes are reusable.
Serving Walnut Park, CA – Our Local Coverage Area
We serve Walnut Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Walnut Park

Most residential chain link jobs take one to three days on site: a day for digging and setting posts, then a day or two for frame, mesh, and gates after the concrete sets. Larger perimeters or jobs needing old-fence removal push toward the three-day mark. Call (833) 842-7204 to get a specific timeline for your line.
It depends on height, location, and whether the fence sits on a property line or an alley easement. Because Walnut Park is unincorporated, that determination runs through County codes, not a city counter. We check the requirement for your specific run and tell you before work starts – call (833) 842-7204 to ask about your property.
In most cases yes. We call for a utility locate before digging and lay out posts around known laterals and the garage line, so the fence avoids conflicts rather than forcing a reroute. When a lateral sits directly on the line, we adjust post spacing and tell you what changed. Call (833) 842-7204 to walk through your lot.
Residential chain link in Walnut Park runs $3,500 – $9,000 depending on footage, mesh gauge, gate count, and old-fence removal. The written estimate breaks out each line so you can see the drivers. Call (833) 842-7204 for an exact quote – estimates are free.
Our workmanship is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. Material warranties come from the manufacturer and vary by product. Call (833) 842-7204 with questions about coverage on your job.
Fencing often lines up with other outdoor work. Homeowners here pair a new fence with ADU Site Prep & Utilities in Walnut Park when a rear garage is being converted, or with Door Installation in Walnut Park when a gate and entry door are being updated together. For anything across the broader Walnut Park area, we’re glad to talk through the full scope.
Get a Free Chain Link Fence Estimate in Walnut Park
Call (833) 842-7204 to schedule a free on-site estimate for your chain link fence in Walnut Park. We’ll measure the run, check setbacks and utilities, and hand you a written line-item quote with the gauge, coating, and footing spec spelled out. No-hassle upfront pricing, 0% financing for 18 months available, and $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












