







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Gardena: What It Costs and How Long It Takes
A chain link fence in Gardena runs $3500 to $9000 for a typical residential install, and most of our jobs close out in 2 to 3 working days once permits are in hand. You’re getting galvanized steel pipe posts set in concrete, a tensioned chain mesh fabric, and hardware that survives the South Bay’s salt-heavy morning air. Call (833) 842-7204 and we’ll walk your property line, measure the actual run, and put a fixed number in writing.
How a Chain Link Fence Goes In, Stage by Stage

Chain link moves fast compared to wood or masonry, but it still has a real sequence. Here’s what actually happens on a Gardena install.
Stage 1: Site walk and layout (day 1, about 90 minutes)
We meet you on site, pull a string line, and mark every terminal post, corner, and gate location with paint. This is where you decide the fence height and whether the run ties into an existing structure or stands free. On the small mid-century lots common in 90247 and 90249, we also check the property line against your survey before a single hole gets dug – the old detached garages here sit close enough to the line that “close” and “on the line” are two very different conversations.
Stage 2: Utility locate before any digging (day 1, before we break ground)
We call in the 811 locate service and wait for the marks, which in Gardena typically clears within 2 business days. This is non-negotiable. Older South Bay lots have irrigation, gas, and electrical running at depths that predate current standards, and a post hole is a bad way to find out. You don’t have to do anything here; we handle the ticket.
Stage 3: Demolition and post setting (day 2, full day)
If there’s an old fence coming out, we pull it, haul it, and remove the old concrete footings. Then we auger new holes 24 to 36 inches deep depending on soil and post size, set line posts and terminal posts in concrete, and let them cure. Terminal posts – the corners, ends, and gate posts – get a bigger hole and more concrete because they carry the tension load for the whole run.
Stage 4: Top rail, tension wire, and fabric (day 3, half to full day)
Once the concrete has set, we run the top rail through the post loops, string the tension wire along the bottom, then stretch the chain link fabric and tie it off. Gate frames go in with hinges set for the swing you chose. We tension by hand with a come-along, checking that the fabric has no slack waves between posts.
Stage 5: Walkthrough and adjustments (day 3, about 30 minutes)
We walk the whole line with you, open and close the gate, check that the latch catches clean, and confirm the height at the highest grade point on the property. Anything that needs a tweak gets fixed before we pack up. You get a written record of the install and the warranty terms in hand.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
Chain link isn’t one product. It’s a set of decisions that move the price and the lifespan. Here’s what matters.
- Fabric gauge: 11.5 gauge is the residential standard and the right call for most yards. 9 gauge is heavier and costs about 20% more but is the better pick on a property line that gets bumped by vehicles or pets. 12.5 gauge is lighter and cheaper; we don’t push it unless the run is short and low-traffic.
- Mesh size: 2-inch mesh is the default. 1-5/8 inch is tighter and reads as more secure, at a modest premium. 2-3/8 inch is common on commercial and agricultural runs.
- Coating: Galvanized steel is the workhorse – strong, affordable, and the standard finish. Vinyl-coated chain link (usually green or black) adds a few hundred dollars to the run and gives you a color that reads less industrial against a stucco house. The coating also slows the corrosion that the South Bay’s marine layer pushes along.
- Height: 4-foot, 5-foot, and 6-foot are the common residential heights. 6-foot gives real screening and is often the minimum a pool barrier requires – we’ll confirm what your specific situation needs during the walk.
- Gates: A standard 3-foot walk gate costs less than a 10-foot double drive gate. Gate construction matters more than people expect – a cheap gate that sags in a year is the most common complaint on any chain link job.
- Post and rail gauge: Heavier pipe posts and top rail hold tension better over 20 years. It’s a small line item relative to the total and worth the upgrade.
What a Chain Link Fence Costs in Gardena, CA

The lead range is $3500 to $9000, with most residential Gardena installs landing between $4500 and $6500 for a standard 4-to-6-foot run with one walk gate. Here’s what pushes the number up or down.
| Line item | Typical range |
|---|---|
| Standard residential run, 4-6 ft, one walk gate | $3,500 – $6,500 |
| Larger lot or multiple gates | $6,500 – $9,000 |
| Demo and haul-away of an existing fence | $350 – $900 |
| Vinyl coating upgrade | $300 – $800 |
| Double drive gate | $600 – $1,400 |
| Permit and inspection | varies by scope |
The variables that move the price: linear feet is the biggest driver – a corner-lot run of 200 feet costs proportionally more than 100. Number of gates adds hardware and framing labor. Existing fence removal is a real line item if old footings have to come out. Terrain and clearance matters here more than in flat inland cities; sloped yards in the hillside pockets need stepped panels or racked fabric, and tight property lines mean slower, more careful work. Material grade – heavier gauge fabric and pipe – pushes cost up but also lifespan.
A written estimate from us lists every one of those lines by quantity and unit price. It also states what’s included and what isn’t – specifically whether permit fees are pass-through or fixed, and whether old fence haul-away is in the total. Our upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Gardena’s Housing Stock Does to a Chain Link Job
Gardena’s housing is mostly 1940s-to-1960s single-story stucco on small lots, and the fences that have been up on those lots for the last 40 years are usually at the end of their life. What we see on the ground: rust-through at the bottom rail and post bases where the soil stays damp from the marine fog, sagging fabric from a gate or post that shifted with the old detached-garage footings, and mixed fencing where a prior owner patched a section with a different gauge. On the tight 5,000-to-7,000 square-foot parcels, the fence often runs right up against a garage wall, so the fence install and any garage work happen in the same narrow corridor. If a property is heading toward a garage conversion or an addition, homeowners often pair the fence work with the site planning on ADU Site Prep & Utilities in Gardena so the utility trenching and the fence layout get coordinated instead of re-done.
Permits are a step you can’t skip on fences over 6 feet or on any fence near a pool. Gardena handles building permits through the city, and pool safety barriers have their own inspection sequence tied to state code. We pull the permit, schedule the inspection, and pass it before the job closes. As part of a full Fence Installation in Gardena scope, or paired with Door Installation in Gardena on a detached garage that needs a proper exterior door, the fence and the structure work together. We serve every corner of Gardena – 90247, 90248, and 90249 – and our fence installation service is documented end to end through Fence Installation.
Serving Gardena, CA – Our Local Coverage Area
We serve Gardena and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Gardena

Two to three working days for most residential runs, once permits and utility locates are cleared. The one variable that pushes it is the 811 utility locate, which can add 2 business days before any digging starts. We schedule around it so the clock doesn’t stall. Call (833) 842-7204 to get a specific timeline for your lot.
Yes if the fence exceeds 6 feet, runs near a pool, or sits on a corner with a sight-line restriction. Standard 6-foot-or-under rear and side yard fencing sometimes clears without a permit, but the rules depend on front-yard placement and the corner-visibility zone, so we check the specific address before committing. We handle the permit pull and the inspection when one is required. Call (833) 842-7204 and we’ll tell you for your address.
$3500 to $9000 for a full residential run, with the median install sitting in the $4500 to $6500 range. Gates, demo of an old fence, vinyl coating, and terrain add to that – and you’ll see every line itemized in a written estimate. Call (833) 842-7204 for an exact quote; estimates are free.
No. We price the job from the on-site walk and a written scope, and the number you sign is the number you pay. The only thing that changes a fixed price is a change you request mid-job, like adding a gate or extending the run. Call (833) 842-7204 to schedule the estimate.
Every chain link install is backed by our 730-Day Done Right Promise – if the workmanship fails, we make it right. That covers the install, tensioning, and gate alignment for two full years, not a 30-day window. Material warranties come from the manufacturer on top of that. Call (833) 842-7204 with questions before you book.
Get a Chain Link Fence Estimate in Gardena
Call (833) 842-7204 for a free on-site estimate. We’ll walk the run, mark the posts, and hand you a written line-item quote with a fixed price and a clear scope – no surprises on the back end. Every install is backed by our 730-Day Done Right Promise. Our technicians have up to 12 years of experience, and estimates are always free.
Written by the team at Groundwork Construction Co.












